Speaking of plastic mold may be a lot of people think this term is very strange, but if it comes to plastic products, many people may feel better understood. In fact, plastic mold is mainly used to produce a plastic mold products only. So in the end this kind of mold can be used in what place? Let me take you a brief look at today.
In fact, many places in our life can see the plastic products manufacturing plant, most of the plastic products are produced through the plastic mold. Because the plastic products commonly used in our lives, no matter what are common, if the large number of daily necessities need a single production, it would waste a lot of manpower and resources, if it is made by the method of plastic mold will save Go to a lot of trouble. Because after the production of a mold through this mold to produce tens of thousands of exactly the same plastic products.
Mold injection molding is a processing method used in the mass production of certain complex shapes. The specific principle refers to: the plastic material melted by heat will be pushed into the mold cavity of the plastic mold by the screw of the injection molding machine and cooled and solidified to obtain the plastic shaped product.
The plastic mold consists of a moving mold and a fixed mold. The moving mold is installed on the moving template of the injection molding machine and the fixed mold is installed on the fixed mold of the injection molding machine. During injection molding, the movable mold and the fixed mold are closed to form a pouring system and a cavity. When the mold is opened, the movable mold and the fixed mold are separated to remove the plastic product. Although the structure of the plastic mold may vary due to the variety and performance of the plastic, the shape and structure of the plastic and the type of the injection machine, the basic structure is the same.
Plastic mold structure by function points, mainly by: pouring system, temperature control system, molding parts system, exhaust system, the guidance system, the top of the system components. One casting system and molding parts are in direct contact with the plastic part, and with the plastic and products change, is the most complex mold, the most varied, requiring the highest processing finish and precision part. In fact, the plastic mold is not difficult, no matter how the change of plastic products, plastic mold to the molding of this product, its structure is nothing more than the above aspects.
https://www.essaii.com/wp-content/uploads/2019/02/essai.jpg00Adminhttps://www.essaii.com/wp-content/uploads/2019/02/essai.jpgAdmin2019-01-08 03:35:562019-01-08 03:37:20Plastic Mold By The Dynamic Mode And Fixed Mold In Two Parts
Looking to the future, we will adhere to our commitment to excellence in the engineering, manufacturing, innovation, quality and affordability of our products.